Why We Only Use Stamoid for Boat Sun Shades

Every Sunshade National Canvas builds is made from Stamoid, a PVC-coated polyester marine fabric, and we do not offer anything else. That is a deliberate choice, not a limitation: Stamoid is 100% waterproof, blocks UVB completely, has almost no stretch, is light enough not to sag between poles, and is backed by a 5-year warranty. Here is why one fabric is the right answer for a Sunshade, and an honest look at what the alternatives give up.

What Stamoid is

Stamoid is a woven high-tenacity polyester base coated on both sides with PVC. The weave gives it strength and dimensional stability. The coating seals it, which is what makes it waterproof rather than water resistant, and gives it a smooth surface that sheds salt and dirt with a rinse. It has been a standard marine cover fabric for decades.

A Sunshade lives a different life from a bimini or a cover. It is stretched between a hardtop and a set of poles for a few hours, run with, taken down, and stuffed into a bag. It needs to hold tension without stretching, stay light enough for telescoping poles to carry, and tolerate being stowed wet. Stamoid does all three.

100% waterproof: stow it wet, no mildew in the weave

A Sunshade comes down when it rains, which means it comes down wet, gets stuffed in a locker and is forgotten until next weekend. A woven canvas holds water in its fibers, and wet fibers in a closed locker is how mildew starts.

Stamoid holds no water in the weave because the weave is sealed. Water sits on the surface and runs off. You can stuff a Stamoid Sunshade wet, every time, with no mildew held in the weave. That is why there is no folding routine and no drying routine. Shade down, into the bag, done.

Blocks UVB completely

The shade under a Stamoid panel is real shade. The fabric is opaque; it does not pass light through the weave the way an open fabric does. Stamoid blocks UVB completely, so the cockpit or bow under the shade is a different place to be at two in the afternoon in July.

No stretch and no memory

This is the property owners never think about and the one that matters most. Our shades are patterned in 3D and built to the mount-to-mount number to an eighth of an inch, with a catenary curve on every edge so that tensioning the corners pulls the whole edge tight and clean. That only works if the fabric is the same size every time you put it up.

Stamoid has almost no stretch and almost no shrinkage. It does not grow when it is loaded, and it does not take a set from being stuffed in a bag. So the shade that pulled tight and clean on the first day pulls tight and clean in year five. A fabric that stretches needs re-tensioning through the day and slowly loses its shape; a fabric with memory keeps the creases it was stored in. Stamoid does neither. With lifetime thread (PTFE) on every seam, double-reinforced sides and triple-reinforced corners, the shade has a fixed geometry that the poles and strings simply load.

Light weight: no sag between poles

A Sunshade is held up by poles in rod holders, not by a frame, so every ounce of fabric between those poles is weight the fabric carries across its own span. A heavy fabric droops in the middle no matter how well the corners are tensioned, and a droop collects water and catches wind.

Stamoid is light for its strength, which lets us span a bow or a cockpit with the edges pulled tight and no belly in the panel, and it is why the whole kit, shade and poles together, stows in a locker.

14 colors, 5-year warranty

Stamoid comes in 14 colors, so the shade can match the hardtop, the hull, or the canvas already on the boat.

Stamoid is 100% waterproof, blocks UVB completely, and is backed by a 5-year warranty. In practice it lasts a good deal longer, because a Sunshade is deployed for a few hours at a time rather than left standing in the sun year round, and the shades we have built have run 10 years and more.

An honest comparison with breathable canvas

Breathable acrylic canvas is a fine fabric. It is what most biminis and many boat covers are made of, and it earns that place because a cover that lives on the boat full time needs to breathe so condensation can escape.

It is the wrong choice for a Sunshade, for three reasons. First, it is not waterproof. It is water resistant, so it wets through in a hard rain and holds water in the fibers afterward, and a shade stowed wet is a shade growing mildew. Second, it stretches. A woven acrylic relaxes under load and in heat, so the tight, clean edge you set in the morning is looser by the afternoon, and over seasons the pattern drifts. Third, it is heavier for the same coverage, and on a pole-supported panel that weight shows up as sag.

Open-weave shade fabrics have the opposite problem. They let light and some rain through by design, and the open structure has even less resistance to stretch, so a panel tensioned from four corners never quite pulls tight.

Stamoid gives up one thing: it does not breathe. On a Sunshade that does not matter, because the shade is open on every side and comes down when you are done.

One fabric, built right

Because we build in one fabric, every detail of our construction standard is tuned to it: the depth of the catenary curves, the reinforcement at sides and corners, the corner hardware and the tensioning strings. You get the Sunshade we know how to build, in the color you want, for a center console, a sport fisher, a motor yacht or a Superyacht. See them in the gallery.

Frequently asked questions

Is Stamoid waterproof or just water resistant?

Waterproof. The polyester weave is coated on both sides, so water cannot pass through the fabric or soak into the fibers. Water resistant fabrics, including breathable acrylic canvas, slow water down but wet through in a steady rain and hold moisture afterward. On a Sunshade the difference matters most at stowing time, since a waterproof shade can go into its bag wet.

Can I stow a wet Stamoid Sunshade in its bag?

Yes. That is one of the main reasons we build in Stamoid. Pull the shade down, stuff it in the bag, and put the bag in a locker. There is no need to dry it first and no folding routine. A freshwater rinse now and then is good practice for the hardware, but the fabric itself does not hold water or grow mildew in the weave.

Why not build Sunshades in a breathable acrylic canvas?

Breathable acrylic is a good cover fabric and the wrong Sunshade fabric. It is water resistant rather than waterproof, so it holds water and mildews if stowed wet. It stretches under load and in heat, so a shade patterned to an eighth of an inch loses its tight, clean edge over a day and its shape over seasons. And it is heavier for the same coverage, which shows up as sag between the poles. A Sunshade does not need to breathe because it is open on every side.

How long will a Stamoid Sunshade last?

Stamoid is backed by a 5-year warranty. In practice it lasts a good deal longer, because a Sunshade is deployed for a few hours at a time rather than left standing in the sun year round, and the shades we have built have run 10 years and more. Lifetime thread on every seam means the stitching is not the weak point either, so the shade ages as a whole rather than failing at a seam first.


Ready for a Sunshade built in Stamoid for your boat? Start on the Sunshades page, or order direct: the full kit with poles and mounts from $1,895, or the shade only from $845 if you already have poles. Free shipping anywhere in the US, in-person measure and install from Miami to Jupiter. Call the Sunshade line at (561) 270-6922. We answer the phone 8am to 4pm Eastern, Monday through Friday.

Start Your Project

Let’s start the conversation. Share a few details and we will be in touch.

Let's Talk

This field is for validation purposes and should be left unchanged.